TLC Resource Portal

WINEMATE: P2 OR P3 ERROR CODES


P2 ERROR CODE:TEMPERATURE PROBE/AIR PROBE ERROR
The air senor is either disconnected from back of the thermostat controller and the connections needs to be checked and secured.

The thinner wires would be the sensor legs, they would  slip into the screw clamp ports 11 & 12.
If connections are ok, then the air sensor is faulty and no longer sending signal to thermostat.

TEMP SENSOR WOULD NEED TO BE REPLACED

PART# AND PRICING - WM-1500-602-001 - $93 PLUS TAX, INCLUDING SHIPPING.







Wine Bottle Probe & Digital Control Panel
The probe provides an accurate reading of the temperature of your wine, and this easy-to-use digital control panel makes it simple to change settings.
You will have the following advantages of using a bottle probe.
1) Air temperature in the cabinet may fluctuate, but the wine temperature in the bottle is constant.
2) You can put a cooling unit in a full wine cabinet and show both the air temperature and bottle temperature.

P3 ERROR CODE: BOTTLE/LIQUID PROBE SENSOR:


***For all winemate systems that were purchased with the bottle probe option, 
the bottle probe must be connected and plugged into the receptacle on unit at all times.
Unit will still run and cool as needed yet the BEEPING AND FLASHING of the P3 error code will not stop until bottle probe is connected.

Should P3 error code persist when probe is connected, then the probe is faulty and needs to be replaced.


PART# VT-PROBE - $129 PLUS TAX/FREE SHIPPING



Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.